This post is sponsored by Kreg, but as always, all thoughts and opinions are entirely my own.
We took a little summer break last month from our challenge but we’re back this month with a super fun build project. We teamed up with Kreg and put our woodworking skills to the test using their Kreg Jig. I’ve heard of this tool before but never realized how much of a game changer it was. I seriously can’t believe how easy it is to use and how much easier so many of the projects I’ve done in the past would have been if I had this. I started small and simple with something practical that we actually needed and I’m going to show you how easy it is to make!
DIY Modern Step Stool
Kreg sent us all their Kreg Jig R3 kit which comes with most of what you’ll need but you should also get a clamp as well as more screws depending on the size of your project.
SUPPLIES FOR DIY MODERN STEP STOOL
I don’t know why but I was super intimidated to use this tool and kept putting it off but once I was done I felt silly because it’s SO EASY.
I watched this little video on YouTube just to give me an idea of what all the different pieces did.
That should give you the basic rundown and help you get started.
So first up you’ll want to set your Kreg to the width of your wood. Just line up the arrows with the correct number and you’re good to go.
The kit comes with a little guide that tells you exactly what to set it at as well as what size screws you need.
Then you want to set the drill to the correct length as well. Make sure the top of the little silver washer thing is lined up with the number you want. In this case, I wanted 3/4″, then you can just tighten it to set it. It’s super handy to be able to do this right in the little kit.
Ok so before you start drilling you’re going to want to cut your wood.
STEP 1 -WOOD CUTS
Top – 14″ long
Sides – 10″ long
Middle – 12″ long
After you cut them to length, you want to mitre your two side pieces and middle piece. I used our table saw and set the angle to about 15° then just ran both sides through.
Now you can start using your Kreg! You’ll need to make two pocket holes at the top of each side piece of wood. All you do is clamp your kreg down, insert the drill and give it some power. The drill will stop where you put the washer so it won’t go through the wood.
And that’s how you make pocket holes! So easy, right?
Once you’ve drilled your holes you just insert the screws and use the square drill bit that comes with your kit to attach the wood.
Repeat for both sides.
Then take your middle piece and create two pocket holes on either side of the wood and add your screws to attach and you’re left with this! I took a picture of it upside down so you can see where all my pocket holes are.
Eloise was already a fan.
Then it was time for some stain. I used the same one I used in the rest of the bathroom since this is where it was going – Red Chestnut. Then sealed it up with some Poly.
And now Eloise has the perfect little step stool so she can wash her hands and brush her teeth at the bathroom sink!
I’m so excited to build more stuff with the Kreg and try out some of their other cool products too like their new Accu-Cut and Rip-Cut which help you cut down big sheets of plywood without needing a huge table saw.
And don’t forget to check out all the other insanely awesome projects my bloggy friends made! Seriously, they’re all way cooler than my little stool ha.